For diesel generators, there are domineering outside "leakage" when, then the external leakage of the fault is how to solve it?

Diesel generator set "three leakage": oil leakage, water leakage and leakage phenomenon, easy to cause the generator unit oil consumption increased, power down, parts wear faster and other faults. In order to ensure the normal operation of the diesel generator set and prolong the service life of the generator set, the generator technicians must repair it in time. The following is the Qingzhou Feida generator sets to provide you with diesel generator sets of oil leakage, leakage and leakage of some of the treatment methods:

1, the oil leakage therapy

Diesel engine oil bottom shell, paper pad leakage of cylinder cover, gear chamber cover, crankcase cover and other places, as long as the paper pad intact, joint surface cleaning, can be a layer of butter in the rub on the pad of paper, tighten the bolts can leak. If you change the new paper pad, you should put the new paper in the diesel oil for 10 minutes before installing, then remove it and wipe it. Apply a layer of butter on the joint and then put it on.

2, plus pad leakage therapy

The oil leakage of the oil seal joint of the diesel oil pipe joint can be added with a double smooth thin plastic pad on both sides of the leakproof washer, and the leak can be prevented by hard tightening.

3 、 glue leakage therapy

The diesel engine body parts, such as oil tank, water tank, oil pipe, water pipe etc. the blisters, pores cause leakage, with sticky glue onto clean breakage, leakage resistant effect can be received.

4, liquid sealant treatment leakage

Solid Diesel Engine GASKET defects (such as pit, trench, rupture) formed interface leakage and destructive leakage when applied in solid gasket clean on the joint surface with liquid sealant, after curing can form uniform and stable, continuous adhesion of strippable film gasket can prevent all leakage.

5 、 anaerobic glue leakage treatment

Leakage occurs on the diesel engine ventilation bolt, stud bolt, screw plug etc., with anaerobic adhesive coated in the bolt, screw or screw hole clean, fast curing film forming, filling the part void, and can withstand greater pressure, but also has a strong anti shock and loose fastening function. Such as diesel engine high-pressure oil pipe joint thread, the better effect of leakage control.

6, size restoration glue leakage treatment method

Diesel engine shaft and shaft sleeve, the bearing and the bearing seat, the valve and valve seat, self tight seal, and packing etc. the cup felt leakage, available size plastic coated with recovery of clean parts wear parts, etc. after curing, formed a thin layer of mechanical strength wear resistance and heat resistance, high then, turning, boring, scraping, filing and other mechanical processing, restore the part geometry and the matching accuracy, so as to solve the leakage problem.

7, coating liquid leakage method

Diesel fuel tank, water tank, etc. the crankcase joint leakage, can be done to soak in alcohol, paint smear at the seams can be cleaned leakage. But the paint cost is high, only use in an emergency.